PEG

PEG

GRINDING ENGINES

FM1 - Manual cutting system for valve seats

DESCRIPTION

Manual portable system for cutting valve-seats. It allows to:
1) Restore with only one operation the valve seat angles;
2) Removal the valve seat;
3) Increase the counter bore of the valve seat ring.

PEG FM 1PEG FM 1

BASIC EQUIPMENT

  • Variable inclination milling body with fixing electromagnetic base
  • n°1 flat tool bit
  • n°2 tool bits (1x30°; 1x45°) three angle formtools
  • n°2tool holders
  • n°5 fixed pilots


  • n°1 set service hand tools
  • Tool adjustment gauge
  • Operating manual
  • Plastic Box

OPTIONAL ACCESSORIES

  • Universal bench/wall support for heads
  • Fixed pilots in all sizes and diameters, in both millimeters and inches
  • Fixed pilots in tungsten carbide
  • Electric motorization
  • Vacuum tester

PEG FM 1PEG FM 1


Universal support with FM1

Universal support with FM1

Multipurpose bench with FM1

Multipurpose bench with FM1

PLATES ON REQUEST

Complete range of tool bits for all engines. For special orders, state the hardness and dimensions of the valve seat, as per drawing.

PEG FM 1PEG FM 1

MAIN CHARACTERISTICS

Minimum diameter of milling18 mm
Diameter of milling65 mm
Minimum diameter valve seat rings28 mm
Diameter valve seat rings70 mm
Chuck travel15 mm

ENGINE FM1

Motor feedV 230 1PH - V 400 3PH
Motor powerKw 0,24 x 1PH - Kw 0,37 x 3PH
Revolutions in exitg/min 56

FM1 ENGINE WITH VARIABLE SPEED

Motor feedV 230 3PH
Variable speed controlV 230 1PH
Motor powerKw 0,37
Min revolutions in exitg/min 30
Maximum revolutions in exitg/min 100